IEI Integration NANO-9452 v4.01 - Manual (Page 91)

NANO-9452 EPIC Motherboard
Page 73
Figure 5-7: CF Card Installation
5.4 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper. Figure 5-8: Jumper Locations
Before the NANO-9452 is installed in the system, the jumpers must be set in accordance
with the desired configuration. The jumpers on the NANO-9452 are listed in Table 5-1.