IEI Integration NANO-QM57A - Manual (Page 52)

NANO-QM57A EPIC SBC
Page 40
Figure 4-6: AT Auto Button Select Jumper Settings
4.5.2 AT/ATX Power Select Jumper Settings
Jumper Label: J_ATXCTL1
Jumper Type: 3-pin header (1x3)
Jumper Settings: See Table 4-3
Jumper Location: See Figure 4-7
The AT/ATX Power Select jumper specifies the systems power mode as AT or ATX.
AT/ATX Power Select jumper settings are shown in Table 4-3.
AT Power Select Description
Short 1 - 2 Use ATX power
Short 2 – 3 Use AT power Default
Table 4-3: AT/ATX Power Select Jumper Settings
The location of the AT/ATX Power Select jumper is shown in Figure 4-7 below.
Figure 4-7: AT/ATX Power Select Jumper Location