IEI Integration NANO-QM57A - Manual (Page 65)

NANO-QM57A EPIC SBC
Page 53
Step 5: Align the VGA connector. Align the male DB-15 connector on the VGA screen
cable with the female DB-15 connector on the external peripheral interface.
Step 6: Insert the VGA connector. Once the connectors are properly aligned, insert the
male connector from the VGA screen into the female connector on the
NANO-QM57A. See
5
Figure 4-18.
Figure 4-18: VGA Connector
Step 7: Secure the connector. Secure the DB-15 VGA connector from the VGA
monitor to the external interface by tightening the two retention screws on either
side of the connector. Step 0:
4.9 Software Installation
All the drivers for the NANO-QM57A are on the CD that came with the system. To install
the drivers, please follow the steps below.
Step 1: Insert the CD into a CD drive connected to the system.