IEI Integration NANO-9453 v1.12 - Manual (Page 112)

NANO-9453 EPIC Motherboard
Page 94
5.6.2 IDE Cable Connection
The IDE flat cable connects to the NANO-9453 to one or two IDE devices. To connect an
IDE HDD to the NANO-9453 please follow the instructions below.
Step 4: Locate the IDE connector. The location/s of the IDE device connector/s is/are
shown in Chapter 3.
Step 5: Insert the connector. Connect the IDE cable connector to the onboard
connector. See Figure 5-14. A key on the front of the cable connector ensures it
can only be inserted in one direction.
Figure 5-14: IDE Cable Connection
Step 6: Connect the cable to an IDE device. Connect the two connectors on the other
side of the cable to one or two IDE devices. Make sure that pin 1 on the cable
corresponds to pin 1 on the connector Step 0: