5 sata drive connection, Figure 5-17: 5.1 channel audio kit – IEI Integration NANO-9453 v1.12 User Manual
Page 116
NANO-9453 EPIC Motherboard
Page 98
Figure 5-16: 5.1 Channel Audio Kit
Step 4:
Mount the audio kit onto the chassis. Once the audio kit is connected to the
NANO-9453, secure the audio kit bracket to the system chassis.
Step 5:
Connect the audio devices. Connect one speaker to the line-in audio jack, one
speaker to the line-out audio jack and a microphone to the mic-in audio jack.
Step 6:
Install the driver. If the 5.1 channel audio kit is used, the ALC655 Realtek
codec driver must be installed. Refer to Chapter 7 for driver installation
instructions.
Step 0: Step 0:
5.6.5 SATA Drive Connection
The NANO-9453 is shipped with two SATA drive cables and one SATA drive power cable.
To connect the SATA drives to the connectors, please follow the steps below.
Step 1:
Locate the connectors. The locations of the SATA drive connectors are shown