IEI Integration NANO-HM650 - Manual (Page 71)

NANO-HM650 EP IC S BC
P a g e 56
Figure 4-15: Connect Power Cable to Power Supply
4.5.2 Au d io Kit In s ta lla tio n
The Audio Kit that came with the NANO-HM650 connects to the audio connector on the
NANO-HM650. The audio kit consists of three audio jacks. Mic-in connects to a
microphone. Line-in provides a stereo line-level input to connect to the output of an audio
device. Line-out, a stereo line-level output, connects to two amplified speakers. To install
the audio kit, please refer to the steps below:
S te p 1: Locate the audio connector. The location of the 10-pin audio connector is
shown in Chapter 3.
S te p 2: Align pin 1. Align pin 1 on the on-board connector with pin 1 on the audio kit
connector. Pin 1 on the audio kit connector is indicated with a white dot. See
Figure 4-15.