IEI Integration NANO-QM770 - Manual (Page 72)

NANO-QM770 EPIC SBC
Page 57
Step 2: Align the DVI-I connector. Align the male DVI-I connector on the digital display
device cable with the female DVI-I connector on the external peripheral
interface.
Step 3: Insert the DVI-I connector . Once the connectors are properly aligned with the
male connector, insert the male connector from the digital display device into the
female connector on the NANO-QM770. See Figure 4-15.
Figure 4-15: DVI Connector
Step 4: Secure the connector. Secure the DVI-I connector from the digital display
device to the external interface by tightening the two retention screws on either
side of the connector. Step 0:
4.8.2 HDMI Display Device Connection
The HDMI connector transmits a digital signal to compatible HDMI display devices such
as a TV or computer screen. To connect the HDMI cable to the NANO-QM770, follow the
steps below.
Step 1: Locate the HDMI connector. The location is shown in Chapter 3.