IEI Integration TANK-101B-D525_N455 v1.02 - Manual (Page 26)

TANK-101B/BW Embedded System
Page 15
Figure 3-2: CF Card Installation
3.3 Hard Disk Drive (HDD) Installation
To install the hard drive, please follow the steps below:
Step 1: Remove the bottom panel by removing the 10 retention screws from the bottom
panel (Figure 3-3).
Figure 3-3: Bottom Panel Retention Screws
Step 2: Open the bottom panel, unplug the SATA signal and power cables connected to
the TANK-101B/BW, and then put the bottom panel on a flat surface.