A.2.5 create factory default image, Figure a-10: press f3 to boot into recovery mode, Figure a-11: recovery tool menu – IEI Integration TANK-700-QM67 v1.12 User Manual
Page 108: A.2.5
TANK-700 Embedded System
Page 96
A.2.5 Create Factory Default Image
NOTE:
Before creating the factory default image, please configure the system
to a factory default environment, including driver and application
installations.
To create a factory default image, please follow the steps below.
Step 1:
Turn on the system. When the following screen displays (
75
Figure A-10
), press
the <F3> key to access the recovery tool. The message will display for 10
seconds, please press F3 before the system boots into the operating system.
Figure A-10: Press F3 to Boot into Recovery Mode
Step 2:
The recovery tool menu appears. Type <4> and press <Enter>. (
75
Figure A-11
)
Figure A-11: Recovery Tool Menu
Step 3:
The About Symantec Ghost window appears. Click OK button to continue.