IEI Integration TANK-700-QM67 v1.12 - Manual (Page 34)

TANK-700 Embedded System
Page 22
3.7 SO-DIMM Installation
WARNING:
Using incorrectly specified SO-DIMM may cause permanently damage
the TANK-700. Please make sure the purchased SO-DIMM complies
with the memory specifications of the TANK-700.
To install a SO-DIMM into a SO-DIMM socket, please follow the steps below.
Step 1: Remove the bottom panel by removing the 10 retention screws from the bottom
panel (Figure 3-1).
Step 2: Remove the 8 retention screws (Figure 3-9), unplug the SATA signal and power
cables connected to the TANK-700, and then lift the bracket out of the
TANK-700.
Figure 3-9: Retention Screws
Step 3: Locate the SO-DIMM socket on the motherboard (Figure 3-10).