IEI Integration IOPS-Q67_H61 - Manual (Page 29)

IOPS-Q67/H61 Pluggable Module PC
Page 19
3.4.5 RS-232 Serial Port Connector
CN Label: Serial Port
CN Type: RJ-45
CN Pinouts: See Table 3-4
The RS-232 serial port connector allows connection to a serial device.
Pin Description Pin Description
1 DCD 7 DT
2 DSR 8 RI
3 SIN 9 GND
4 RTS 10 GND
5 SOUT 11 N/C
6 CTS 12 N/C
Table 3-4: Serial Port Pinouts
Figure 3-5: RJ-45 Serial Port Connector
Follow the steps below to connect a serial device to the RJ-45 serial port connector of the
IOPS-Q67/H61.
Step 1: Locate the RJ-45 serial port . The location of the RJ-45 serial port is shown in
Chapter 1 .
Step 2: Connect the RJ-45 to COM port cable to the panel PC. Insert the RJ-45
connector end of cable into the RJ-45 serial port. See Figure 3-6.
Step 3: Connect the serial device. Connect a serial device to the DB-9 connector end of
the cable. See Figure 3-6.