IEI Integration ECN-360A-HM65 - Manual (Page 34)

ECN-360A-HM65 Em b e d d e d S ys te m
P a g e 21
Figure 3-9: DB-9 Serial Port Connector
S te p 3: Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
S tep 0:
3.6.5 US B De vic e Co n n e c tio n
NOTE:
User must install the USB 3.0 driver before connecting a USB device to
the system or else the system may not recognize the connected
device.
There are four USB 3.0 connectors and two USB 2.0 connectors on the ECN-360A-HM65.
To connect a USB device, please follow the instructions below.
S te p 1: Locate the USB connectors. The locations of the USB connectors are shown
in Chapter 1.
S te p 2: Align the connectors. Align the USB device connector with one of the
connectors on the external peripheral interface. See Figure 3-10.