IEI Integration UPC-12AH_GM45 v2.00 - Manual (Page 61)

UPC-12A/GM45 Panel PC
Page 49
Figure 4-17: Suggested Panel Cut Out Size for UPC-12A/GM45 (Unit: mm)
Step 3: Slide the flat panel computer through the previously cut hole. The chassis at the
rear of the flat panel should slide easily through the hole. Only stop sliding the
panel through the hole when the back of the front aluminum frame is flush
against the panel.
Step 4: Insert the panel mounting clamps into the pre-formed holes along the edges of
the chassis, behind the aluminum frame. There are a total of 6 panel mounting
clamps for UPC-12A/GM45.
Figure 4-18: Panel Mounting Clamp Slots (Side View)