IEI Integration AFL-W15A_17D-GM45 v3.00 - Manual (Page 24)

AFL-W15A/17D-GM45 Panel PC
Page 13
Step 4: Remove the four HDD bracket retention screws (
5
Figure 2-2) and lift the HDD
brackets out of the panel PC.
Figure 2-2: HDD Bracket Retention Screws
Step 5: Attach the HDD brackets to the HDD. The brackets are different for each side.
Make sure the side with the hard drive screw hole further from the end goes at
the SATA connector end as shown in
5
Figure 2-3.
Figure 2-3: HDD Retention Screws
Step 6: Install the hard drive in the same position it was before.
Step 7: Slide down from the top to connect the motherboard SATA connector to the hard
drive SATA connector.