IEI Integration AFL-15A-N270 v2.20 - Manual (Page 38)

AFOLUX AFL-15A-N270 Panel PC
Page 38
4.5 Removing the Rear Panel
WARNING:
Over-tightening back cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
To access the AFL-15A-N270 internally the rear panel must be removed. To remove the
rear panel, please follow the steps below.
Step 1: Remove the 16 retention screws (Figure 4-1).
Figure 4-1: Back Cover Retention Screws
Step 2: Lift the cover off the AFL-15A-N270 panel PC. Step 0:
4.6 CF Card Installation
The AFL-15A-N270 series has one CF Type II slot inside the rear panel. To install the CF
card, follow the instructions below.
Step 1: Remove the back cover. See Section 4.5.
Step 2: Locate the CF slot in the left panel.