IEI Integration AFL-15A-N270 v2.20 - Manual (Page 55)

AFOLUX AFL-15A-N270 Panel PC
Page 55
Figure 4-15: AFL-15A-N270 Panel Opening (Unit: mm)
Step 3: Slide the flat panel PC through the hole until the frame is flush against the panel.
Step 4: Align the panel mounting bracket screw holes with the VESA mounting holes on
the rear of the panel PC.
Step 5: Secure the two panel mounting brackets to the rear of the panel PC by inserting
the four retention screws into the VESA mounting holes (Figure 4-16 ).
Step 6: Insert the panel mounting clamps into the pre-formed holes along the two edges
of the panel mounting brackets (Figure 4-16 ). There are a total of 4 panel
mounting clamps for AFL-15A-N270.
Step 7: Tighten the screws that pass through the panel mounting clamps until the plastic
caps at the front of all the screws are firmly secured to the panel
(Figure 4-16 ).