5 replacing components, 1 memory module replacement, Eplacing – IEI Integration AFL-15A-N270 v2.20 User Manual

Page 66: Omponents, Figure 5-3: so-dimm socket location

Advertising

AFOLUX AFL-15A-N270 Panel PC

Page 66

5.5 Replacing Components

5.5.1 Memory Module Replacement

The flat panel PC is preinstalled with a 1.0 GB DDR2 memory module. If the memory

module is fail, follow the instructions below to replace the memory module.

Step 1:

Remove the back cover. See Section 5.4.1 above.

Step 2:

Remove the internal aluminum back cover. See Section 5.4.2 above.

Step 3:

Locate the DDR2 SO-DIMM on the motherboard (Figure 5-3).

Figure 5-3: SO-DIMM Socket Location

Step 4:

Remove the DDR memory module by pulling both the spring retainer clips

outward from the socket.

Step 5:

Grasp the DDR memory module by the edges and carefully pull it out of the

socket.

Step 6:

Install the new DDR memory module by pushing it into the socket at an angle

Step 7:

Gently pull the spring retainer clips of the SO-DIMM socket out and push the

rear of the DDR memory module down (Figure 5-4).

Advertising