IEI Integration AFL-xxA-N270-Series v2.00 - Manual (Page 47)

AFL-xxA-N270 Series Panel PC
Page 32
4.5 Removing the Back Cover
WARNING:
Over-tightening back cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
To access the AFL-xxA-N270 internally the back cover must be removed. To remove the
back cover, please follow the steps below.
Step 1: Remove the retention screws (Figure 4-1) and lift the cover off the flat panel PC.
Figure 4-1: Back Cover Retention Screws
Step 2: Lift the cover off and pull down the cover a bit to make it possible to lift the cover
further more after removing the retention screws (Figure 4-2). More strength is
required to separate the cover from the chassis. Step 2:
Figure 4-2: AFL-xxA-N270 Plastic Back Cover Removal