IEI Integration AFL-xxA-N270-Series v2.00 - Manual (Page 65)

AFL-xxA-N270 Series Panel PC
Page 50
Figure 4-19: Tighten the Panel Mounting Clamp Screws
4.10.3 Arm Mounting
The AFL-xxA-N270 series is VESA (Video Electronics Standards Association) compliant
and can be mounted on an arm with a 75mm or 100mm interface pad. To mount the
AFL-xxA-N270 series on an arm, please follow the steps below.
Step 15: The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.
NOTE:
When purchasing the arm please ensure that it is VESA compliant and that
the arm has a 75 mm interface pad. If the mounting arm is not VESA
compliant it cannot be used to support the AFL-xxA-N270 series flat panel
PC. The AFL-10A-N270 and AFL-12A-N270 also support VESA MIS-D
100.