IEI Integration AFL-W10A-N270 v3.20 - Manual (Page 33)

AFL-W10A-N270 User Manual
Page 19
ƒ Self-service kiosk
ƒ Plant environment monitoring system
ƒ Factory automation platform
ƒ Manufacturing shop flow
2.4.2 ATX Power Mode
With the ATX mode selected, the AFL-W10A-N270 panel PC goes in a standby mode
when it is turned off. The panel PC can be easily turned on via network or a power switch
in standby mode. Remote power control is perfect for advertising applications since the
broadcasting time for each panel PC can be set individually and controlled remotely. Other
possible application includes
ƒ Security surveillance
ƒ Point-of-Sale (POS)
ƒ Advertising terminal
2.5 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.
The following jumpers and switches can be changed after removing the rear cover.
Description Label Type
Clear CMOS J_COMS1 2-pin header
COM1 Pin 9 setting JP8 10-pin header