4 memory module replacement – IEI Integration AFL-W10A-N270 v3.20 User Manual
Page 58

AFL-W10A-N270 User Manual
Page 44
3.4 Memory Module Replacement
The panel PC is preinstalled with a 1 GB DDR2 memory module. If the memory module is
fail, follow the instructions below to replace the memory module.
Step 1:
Remove the aluminum back cover. See Section 3.3 above.
Step 2:
Locate the DDR2 SO-DIMM on the motherboard (Figure 3-4).
Figure 3-4:AFL-W10A-N270 SO-DIMM Socket Location
Step 3:
Remove the SO-DIMM by pulling both the spring retainer clips outward from the
socket.
Step 4:
Grasp the SO-DIMM by the edges and carefully pull it out of the socket.
Step 5:
Install the new SO-DIMM by pushing it into the socket at an angle (Figure 3-5).
Step 6:
Push the SO-DIMM down until the spring retainer clips of the SO-DIMM socket
clip into place and secure the SO-DIMM in the socket.
Step 0: