IEI Integration AFL2-W15A-N270 v2.00 - Manual (Page 73)

AFL2-W15A-N270 Panel PC
Page 61
NOTE : Make sure the selected COM port is enabled through the Super I/O configuration
menu.
Base Address, IRQ [3F8h, 4]
The Base Address, IRQ option cannot be configured and only shows the interrupt
address of the serial port listed above.
Serial Port Mode [115200 8,n,1]
Use the Serial Port Mode option to select baud rate through which the console redirection
is made. The following configuration options are available
115200 8,n,1 D
EFAULT
57600 8,n,1
38400 8,n,1
19200 8,n,1
09600 8,n,1
NOTE:
Identical baud rate setting musts be set on the host (a management
computer running a terminal software) and the slave
Redirection After BIOS POST [Always]
Use the Redirection After BIOS POST option to specify when console redirection should
occur.
Disabled The console is not redirected after POST
Boot Loader Redirection is active during POST and during Boot
Loader
Always D EFAULT
Redirection is always active (Some OSes may not
work if set to Always)