IEI Integration POC-17i_19i-Series_IEI - Manual (Page 31)

POC-17i/19i Series
Page 19
Figure 3-2: Aluminum Back Cover Retention Screws
Step 3: Lift the aluminum cover away to expose the mainboard jumpers.
3.6 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.
The following jumpers can be found on the motherboard installed in the POC-17i/19i
Series. Before the POC-17i/19i Series is installed, the jumpers must be set in accordance
with the desired configuration. The jumpers on the POC-17i/19i Series motherboard are
listed in Table 3-1.