3 usb device connection, Figure 3-18: serial device connector – IEI Integration POC-17i_19i-Series_IEI User Manual
Page 50
Advertising
POC-17i/19i Series
Page 38
Figure 3-18: Serial Device Connector
Step 3:
Secure the connector
. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
3.8.3 USB Device Connection
There are four external USB 2.0 connectors. All connectors are perpendicular to the
POC-17i/19i Series. To connect a USB 2.0 or USB 1.1 device, please follow the
instructions below.
Step 1:
Located the USB connectors
. The locations of the USB connectors are shown
in Chapter 2.
Step 2:
Align the connectors.
Align the USB device connector with one of the
connectors on the bottom panel. See Figure 3-19.
Advertising