IEI Integration ICECEARE-10W - Manual (Page 23)

ICECARE-10W Mobile Sales Assistant
Page 11
2.1 Unpack the System
To unpack the ICECARE-10W Series, follow the steps below:
WARNING!
Only remove the protective plastic cover stuck to the front screen after
installation. The plastic layer protects the monitor surface during
installation process.
Step 1: Carefully cut the tape sealing the box. Only cut deep enough to break the tape.
Step 2: Open the box.
Step 3: Lift the ICECARE-10W Series out of the boxes.
Step 4: Remove the peripheral parts box from the main box. S te p 0 :
2.2 Packing List
NOTE:
If any of the components listed in the checklist below are missing, do
not proceed with the installation. Contact the IEI reseller or vendor the
ICECARE-10W Series was purchased from or contact an IEI sales
representative directly by sending an email to
31
[email protected] .
The ICECARE-10W Series is shipped with the following components: