2 charge the sytem, Harge the, Ytem – IEI Integration ICECEARE-10W User Manual
Page 27
ICECARE-10W Mobile Sales Assistant
Page 15
Remove any of the stickers on the PCB board. These stickers are required for
warranty validation.
Use the product before verifying all the cables and power connectors are
properly connected.
Allow screws to come in contact with the PCB circuit, connector pins, or its
components.
3.2 Charge the Sytem
To charge the ICECARE-10W Series, follow the steps below.
Step 1:
Connect the ICECARE-10W Series with a power source through the power
adapter came with the package.
Step 2:
The system starts to charge the battery and the power status LED lights up in
red indicating the battery is being charged. When the battery is fully charged, the
power status LED turns off.
Figure 3-1: Power Input Connector and Power LED Indicator
Step 3:
The user can also turn on the system to check the battery capacity via the
Windows Embedded 7 power management screen (
73
Figure 3-2
).