Maintenance, Safety precautions, Warning – Lincoln Electric IM10125 AutoDrive 19 TANDEM User Manual
Page 21
D-1
MAINTENANCE
D-1
ROUTINE MAINTENANCE
• Check weld cables and control cables for cuts.
PERIODIC MAINTENANCE
• N/A
CALIBRATION SPECIFICATION
All calibration is factory set on the AutoDrive
®
19
Tandem.
AutoDrive
®
19 Tandem
SAFETY PRECAUTIONS
See additional warning information
throughout this operatorʼs manual and
the Engine manual as well.
------------------------------------------------------------
ELECTRIC SHOCK can kill.
• Do not touch electrically live parts
such as output terminals or internal
wiring.
• When inching, electrode and drive
mechanism are “hot” to work and
ground and could remain energized
several seconds after the inch button
is released.
• Turn OFF input power at welding power source
before installation or changing drive roll and/or guide
tubes.
• Welding power source must be connected to system
ground per the National Electrical Code or any
applicable local codes.
• Only qualified personnel should perform mainte-
nance work.
WARNING