Lincoln Electric IMt10143 MARQUETTE AutoPro 140_180 - Manual (Page 13)

A. ITEMS NEEDED FOR
FLUx CORED WELDING
1. .035”(0.9mm) Contact Tip
2. Dual Groove Drive Roll.
3. .035”(0.9mm) NR-211MP Flux-
Cored Wire
4. Black Flux Cored gun nozzle
5. Welding Gun
6. Work Cable & Clamp
.035
.035 NR-211 MP
FLUX-CORED WIR
E
SETTING UP AND MAKING A FLUx-CORED WELD
B-4 OPERATION B-4
AUTOPRO™ (140/180 MODELS)
TABLE B.1
DRIVE ROLLS
Wire Diameter & Type
.025”(0.6mm) MIG wire
.030”(0.8mm) MIG wire
.035”(0.9mm) MIG wire
.030”(0.8mm) flux-cored
.035”(0.9mm) flux-cored
.045”(1.1mm) flux-cored
Smooth Drive Roll
(Dual Grooves)
Use .025”(0.6mm) Drive Roll Groove
Use .035”(0.9mm) Drive Roll Groove
Use .045”(1.1mm) Drive Roll Groove
Drive Roll
Part Number
KP2948-1
KP3285-1*
See Figure B.6
12. CIRCUIT BREAKER – If the rated input current of
the machine is exceeded this circuit breaker will trip.
Press to reset.
13. GAS INLET – Shielding gas connects to this inlet.
12 13
FIGURE B.6
.02
5
.025 GROOVE
.035 GROOVE
OPERA
T
OR’S MANUAL
*KP3285-1 May also be used to feed .030”(0.8mm) and .035”(0.9mm) flux-cored wire.