ODL Brisa Retractable Screen Doors - single doors - Manual (Page 8)

7
Product modification
There are two seperate scenarios that will require modifications before proceeding
to the installation steps. Door trim openings that measure less than 32" will require
track cutting to fit the door width. Outswing door installations require a change to
the handle/lock assembly to move the lock mechanism to the inside of the home.
OUTSWING DOOR
HANDLE MODIFICATION
Remove the two screws on the
handle assembly.
Remove the slider bar end cap and
slide the handle assembly all the way
to the open end of the slider bar.
Slide the handle off completely and
flip the handle end-to-end
Re-insert the handle assembly,
making sure the handle tabs slide
into the tracks of the slider bar.
TIP: Locking latch and housings
should be on the inside of the
home when installed.
Locking
Latch
NARROW DOOR
TRACK MODIFICATION
Measure your door trim opening and
follow the example below to make
your modifications.
EXAMPLE
32"
standard door width
- 30"
existing door width
= 2"
total amount to be cut from
the FLAT ends of the top and
bottom tracks
(Do not cut the notch end of the track)