Pumptec SPRAYER SUB-ASSEMBLY 350U with regulator - Manual (Page 3)

3
Pumptec, Inc. | 700 McKinley St. NW, Anoka, MN 55303 | 763-433-0303 | www.pumptec.com Version 011614
-
The mounting plate should be made of steel or aluminum.
It may be a horizontal or vertical mount plate (for vertical
mounts, the pump must hang below the motor).
-
Drill four holes in your mounting plate with a 5/16” drill bit.
The hole pattern is 4 inches wide by 3.3 inches long.
4” 3.3”
4”
3.3”
If mounting vertical, the pump should
be below the motor, as shown.