Qualcraft Stacker Bracket Frame - Manual (Page 15)

G
ua
rd
ia
n
Fa
ll
Pr
ot
ec
tio
n
6
30
5
S.
2
31
st
S
t.
, K
en
t,
W
A
9
80
32
p
ho
ne
: (
80
0)
4
66
-6
38
5
f
ax
: (
80
0)
6
70
-7
89
2
w
w
w
.g
ua
rd
ia
nf
al
l.c
om
13
14. Insert (3) 2” x 4”, 10’ long Guardrails into corresponding rungs on Guardrail Posts. Ensure
that Guardrails will fully span two consecutive Top Clamp and Support Bracket assemblies, and
will overlap with adjacent Guardrails by a minimum of 12” on each end.
Minimum overlap: 12”
• Compatible Snap-On Metal Adjustable Guardrails (part #s 61075 and 61076, not included) may
be used in substitute of 2” x 4” lumber Guardrails. Snap-On Metal Adjustable Guardrails do not
require lapping. Both ends of Snap-On Metal Adjustable Guardrails MUST be fully locked onto
their corresponding Guardrail Post rungs.
Scaffold Planks and lumber Guardrails MUST overlap a MINIMUM 12” on each end. ! WARNING
15. Complete entire run of Scaffold Planks and Guardrails. Ensure overlapping Scaffold Planks
and Guardrails are lapped in a continuous direction. Continuous lapping simplifies the
disassembly process.
16. If Toeboards are required, attach 2” x 4” lumber Toeboards with a compatible nail or screw
at all Toeboard Attachment locations.
2” x 4” Toeboard
Compatible nail/screw
at Toeboard Attachment
location