Rapid-Air AIR FEED / CUT-TO-LENGTH WITH KEYPAD - Manual (Page 13)

12
1. When pressing the F4 key the display reverts back to the main menu.
2. All manual keys are now active. Pressing any labeled key will activate a movement.
Caution: Make sure there is air to the cutter before cycling or the system will lock
up. To unlock, the main power has to be cycled.
3. Pressing the “Feed Button” will cause the feed to move the number of cycles that
was entered.
4. Pressing the “Cut Button” will cause the cutter to cycle one time.
5. Pressing the “Single Cycle Button” will cause the feed and cutter to perform one
complete cycle.
6. Press the “Total Reset” button and the following display appears.
TOTAL COUNT = XXXXXX
F1=RESET TO ZERO
F4=EXIT DISPLAY
A. Pressing the F1 key will cause the total count to be all zeros.
B. Pressing the F4 key will take you back to the main menu.
7. Press the “Cut Time Button” and the following screen appears.
CUT DWELL TIME=XXX
F1=SET DWELL TIME
F4=EXIT DISPLAY
A. Pressing the F1 key will display a screen which will force you to enter a dwell time
before leaving the screen.
B. Pressing the F4 key will take you back to the main menu.
8. Press the “Clamp Air Button” and the following screen appears.
FEED AIR SELECTION
F1=TURN FEED AIR ON
F2=TURN FEED AIR OFF
F4=EXIT
Use this feature when loading material into the air feed.
9. Press the “Diagnostics Button” and the following display appears.
FEED AT MAIN SW=OFF
FEED AT STOP SW=OFF
CUTTER RET’D SW-ON
DOOR CLOS’D-ON F4=EXIT