Rapid-Air AIR FEED / CUT-TO-LENGTH WITH KEYPAD - Manual (Page 16)

15
Once the number has been entered, the previous screen appears. Press F2 run
current batch and the following screen appears and cycling begins.
AUTO BATCH F4=STOP
FEED PER CYCLE = XX
BATCH COUNT=XXXXXX
TOTAL COUNT=XXXXXX
The batch count will decreemnt while the total count increments. Once the batch size
gets to zero, the auto cycle stops. Pressing F4 at any time stops the cycle and the
following screen appears.
Note: The stop cycle key has to be pressed and held until the sequence that is
currently running is complete.
AUTO CYCLE
WAS STOPPED
F2=CONTINUE CYCLE
F4=STOP AND EXIT
The decision now is whether to continue cycling or stop. If F2 is pressed then the feed
would continue where it left off. If F4 is pressed the following screen will appear.
** AUTOMATIC MODE **
F1=AUTO TOTAL CYCLE
F2=AUTO BATCH CYCLE
F4=EXIT AUTO MODE
Press F4-Exit and the main menu appears.
This completes the programming procedure section of the Air Cut To Length.