Rapid-Air AIR FEED / CUT-TO-LENGTH WITH KEYPAD - Manual (Page 15)

14
At this time the operator can choose to run auto total or exit. If exit is chosen then the
previous screen is displayed. If run is chosen then the following screen is displayed.
** AUTO TOTAL MODE **
FEED PER CYCLE = XX
TOTAL COUNT = XXXXXX
F4=STOP CYCLE
The unit is now in full automatic. Whenever an input for feed is received, the air feed
will feed the cycles programmed and increment the counter by one count.
If you press the F4 “Stop Cycle” key, the automatic cycle will drop out and the next
screen to appear is as follows.
Note: The stop cycle key has to be pressed and held until the sequence that is
currently running is complete.
AUTO CYCLE
WAS STOPPED
F2=CONTINUE CYCLE
F4=STOP AND EXIT
The decision now is whether to continue cycling or stop. If F2 is pressed the feed
would continue where it left off. If F4 is pressed the following screen will appear.
** AUTOMATIC MODE **
F1=AUTO TOTAL CYCLE
F2=AUTO BATCH CYLE
F4=EXIT AUTO MODE
At this time you can choose to go back into auto total. Select auto batch or exit to the
main menu.
Press F2 auto batch cycle and the following screen appears.
BATCH SIZE=XXXXXX
F1=ENTER NEW BATCH
F2=RUN CURRENT BATCH
F4=EXIT AUTO BATCH
If the current batch size is correct then press F2 run current batch. If not then press F1
enter new batch size and the following screen appears.
BATCH SIZE
__________ ENTER
A NUMBER MUST BE
ENTERED TO CONTINUE