Rapid-Air AIR FEED / CUT-TO-LENGTH WITH KEYPAD - Manual (Page 14)

13
Each time the switch changes state, the screen switches to off or on. If the switch is
energized, the screen displays on. If the switch is de-energized, the screen displays
off.
10. Press the “Count Display Button” and the following screen appears.
PART COUNT DISPLAY
TOTAL COUNT=XXXXXX
BATCH COUNT=XXXXXX
F4=EXIT
Pressing the F4 “Exit” key and the screen reverts back to the previous screen.
Press the F4 exit key until the main menu screen appears.
FEED CYCLES/CUT=XX
F1=SET CYCLE PER CUT
F2=MANUAL MODE
F3=AUTOMATIC MODE
We have covered all the setup operations of the Air Cut To Length. Now we will cover
the automatic portion of the programming.
Press the F3 “Auto” key and the following screen appears.
** AUTOMATIC MODE **
F1=AUTO TOTAL CYCLE
F2-AUTO BATCH CYCLE
F4=EXIT AUTO MODE
Pressing the F1 key will put you in the auto total mode. In this mode the feed, once
started, will feed on command until you stop it by pressing the stop key.
Pressing the F2 key will put you in the auto batch mode. In this mode you put in the
quanity of cycles you want and the feed will stop when this count has been reached.
Press F1 auto total cycle key and the following screen appears.
** AUTO TOTAL MODE **
TOTAL COUNTS = XXXXXX
F1=RUN AUTO TOTAL
F2=EXIT AUTO TOTAL