Rapid-Air SERVO FEED: 104CJ, 108CJ, 106CJ, 112CJ - Manual (Page 3)


The CJ servo has many features found
in the more expensive models. Some of
it’s features are:
input:
120 VAC, 50/60 HZ
.
amperage.required.at.input:
10 amps maximum.
.
accuracy:
.0025 per feed length at the rolls.
.
maximum.feed.length.input:
999.999 inches.
.
Job.storage:
99 jobs
.
display:
4 rows by 80 characters, backlit
.
.
INTRODUCTION
the.cJ.servo
The precision mechanical roll feed has
been designed for compactness, ease
of setup and installation. A 120 VAC
receptacle is all that is required of the
customer. Two cables are supplied with
the control and need to be connected
to the proper locations of the motor.
The electrical controls are housed in a
small box that can be mounted on the
press or if purchased, on a post that
can be positioned close to the press.
Fault.type:
Displayed on the drive if a fault occurs
otherwise an “8.” is displayed.
.
rolls:
Hardened and Ground.
.
drive.roll.parallelism.adjustment:
Used to tune the rolls to the material if
needed.
The Rapid-Air CJ feed uses the same
type of programming procedures as it
has in it’s more expensive models. Input
a feed length, strokes per minute, and a
feed arc and the program will adjust the
servo acceleration/deceleration and
maximum servo speed parameters
to the requirement needed to keep up
to the press strokes per minute.
4 keyS weRe CHoSen To HAVe A
DoUble meAnInG, ARRowS AnD
“F” keyS. THe ARRowS weRe
bRoUGHT oUT AS THe pRImARy
InSTeAD oF THe “F” keyS. IF yoU
woUlD beAR wITH US, we ARe
lookInG AT A CoRReCTIon.
keypAD
note: