Proface GP4600R - 12.1 Standard HMIs with Rear Mounting Options" - Manual (Page 31)

32
Eng
lis
h
USB Cable Clamp
2. Removing the USB Cable
3 As shown, pass the tie through the clip hole. Next, turn the tie and
pass it through the head so that the USB cable can pass through
the center of the tie loop. The clip is now attached to the USB
cable.
Note:
• Check the direction of the head beforehand. Make sure the
USB cable is through the center of the tie loop and that the tie
can pass through the head.
• You can substitute the tie provided with PFXZCBCLUSA1
(manufactured by Pro-face) or other commercially available ties
with a width of 4.8 mm [0.19 inch] and thickness of 1.3 mm
[0.05 inch].
4 While pressing the grip on the clip, insert the cable from step 3 all
the way into the USB host interface. Make sure that the clip tab is
secured to the USB cable attached to the GP unit.
Step Action
1 Remove the USB cable while pushing the grip section of the clip.