Proface GP4600R - 12.1 Standard HMIs with Rear Mounting Options" - Manual (Page 34)

35
Standards
En
g
lish
The GP is a device for use in factory systems.
When using the GP in a system, the system should comply with the following
standards in regards to the installation environment and handling.
•
Standard WEEE, Directive 2002/96/EC
• Standard RoHS, Directive 2002/95/EC
• Standard RoHS China, Standard SJ/T 11363-2006
CAUTION
ENVIRONMENTAL HAZARDS TO THE EQUIPMENT
• Allow the device to reach the surrounding air temperature, not exceeding the
following values, before turning the device on:
50°C (122°F): GP-4200 Series, GP-4301TW, GP-4401WW, and GP-4501TW DC
models.
55°C (131°F): GP-4301T, GP-4303T, GP-4401T, GP-4501T/4503T DC models, GP-
4500 Series AC models, and GP-4600 Series.
• Do not turn on the device if condensation has occurred inside the device.
After it is completely dry again, the device may be turned on.
• Do not expose the device to direct sunlight.
• Do not obstruct the vents in the device casing.
• Remove any dust from the device before turning it on.
• Ensure that the cable installation fasteners are not damaged. Replace
them, if necessary.
• Only qualified personnel can change the primary battery.
Failure to follow these instructions can result in injury or equipment
damage.
Inquiry
Do you have any questions about difficulties with your GP?
Please access our site anytime that you need help with a solution.
http://www.pro-face.com/otasuke/
Please be aware that Digital Electronics Corporation shall not be held liable
by the user for any damages, losses, or third party claims arising from the
uses of this product.
Notes