Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 13)

13
(3) Turn the cable connector lock ring to lock the connector, so that the small
U
mark (for
LOCK) on the lock ring is aligned with the small
V
mark on the cable connector.
‹ Removal
(1) Unlock the connector that has been locked in the mounting procedure. (Turn the lock ring as
shown so that the small
U
mark is displaced from the
V
mark). Then, pull out the cable by
holding the cable connector.
• To disconnect the cable, be sure to hold the cable connector and pull it out. If you hold other
parts of the cable (lock ring, etc.), the cable cannot be disconnected.
Align the small
U
and
V
marks to lock the connector.
Lock Ring
2. Pull out the cable by holding the cable connector.
1. Turn the lock ring to unlock the connector.