Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 4)

4
K LAN Status LED
The LED turns ON or OFFto indicate the current status of the
Ethernet transmission interface (10BASE-T/100BASE-TX).
L Hanger
A hanger for temporarily hanging the GP unit on a wall.
• Do not operate or conduct wiring of the GP unit, with the GP
unit hung on a wall.
The GP may fall, resulting in injury or damage to the equip-
ment.
• The following is recommended to be used as pairs for this hanger;
• A
Φ7 or less, rod-shaped or S-shaped hook
• M4 pan-head machine screw, which head diameter is
Φ7 or less.
• Panel thickness: 1 to 1.6mm [0.04 to 0.06 in.],
Panel width: 14mm [0.55 in.]
M
CF Card Access
LED
N
3-Position Enable
Switch
The switch provides three positions: A position where the switch
is not pressed (released), a position where the switch is pressed
to the intermediate position, and a position where the switch is
pressed to the innermost position (fully pressed).
O
Hand Strap
Attachment Slots
⎯
P
GP3000H Cable
Connector (with
Connector Cover)
Connects the GP3000H dedicated cable.
Q Touch Pen
⎯
R
Wall Adapter
Attachment Slots
To mount the GP unit to a panel or commercially available arm,
attach the GP3000H dedicated wall-hanging adapter (optional)
to this slot.
LED Indicates
Green ON Data transmission available
Green Flashing Data transmission is occurring.
Green OFF No connection or subsequent transmission failure
Orange ON During connection with 100BASE-TX
Orange OFF
During connection with 10BASE-T or No
connection
Access LED Indicates
Green ON
Indicates that a CF Card is inserted and DIP Switch 4
is set to ON, or that the CF Card is being accessed.
Green OFF
Indicates that DIP Switch 4 is set to OFF, or that no
CF Card is inserted.