Proface PS4800 - 19 Panel PC" User Manual
Page 103
Hardware Modifications
103
Step
Action
3
Open the blue covers and remove the Torx screws of the PS-B unit:
1 Screw covers
A 2 Torx screws (T10) for PS-B unit 1 slots
B 4 Torx screws (T10) for PS-B unit 2 slots
C1 Only for PS-B unit 5 slots, slide the screw covers with coins on the blue
cover as shown before removing the Tork screws (C2).
C2 6 Torx screws (T10) for PS-B unit 5 slots
4
Remove the side cover by sliding it towards the front.
For PS-B unit 5 slots, remove the side cover by sliding it towards the left.
5
Unscrew the screw from the empty panel and remove the blank panel. Insert the
PCI/PCIe board into the expansion board connector and secure in place using
the filler panel screw.
NOTE: The recommended torque to tighten these screws is 0.5 N•m (4.5 lb-in).
6
Replace the side cover and secure it by inserting the Torx screws.
7
For PS-B unit 5 slots, after Step 6, replace the screw covers.
$
&
%
&