Proface APL3000B - Node Box PC - Manual (Page 54)

Chapter 3 Installation and Wiring
3-11
3.2.6 PCMCIA Unit Installation
(1) Remove the PCMCIA slot cover’s screws (2).
(2) [Inserting a commercial-type PC Card]
Insert the commercial-type PC Card into the PCMCIA connector.
[Removing the PC Card]
Press the eject button twice to remove the PC Card from the PCMCIA connector.
Pressing the eject button once causes its tip to come out.
Pressing the eject button the second ejects the PC Card from the PCMCIA slot.
(3) Replace the PCMCIA slot cover removed in (1) and secure it in place using the two PCMCIA slot
screws. The necessary torque is 0.5N • m to 0.6N • m.
• The PCMCIA slot has 2 connectors. When the PS-A unit is placed as shown below, insert
your PC Card with its face up.
• When using a PC Card with a cable attached, Pro-face recommends you use a
clamp or other type of device to prevent vibration from possibly dislodging the
cable.
• Be sure to stop the PS-A unit PC Card’s driver prior to removing the PC Card. A
failure to stop this driver may result in damage to either the PC Card, the PC
Card's data, or may cause Windows
®
to hang up. For information on the
procedure for stopping the PC Card’s driver, please refer to your OS' User
Manual.
PCMCIA Slot Cover
Eject Button
PC Card (commercial)