Proface APL3000B - Node Box PC - Manual (Page 9)

8
Installation prerequisites for standards
• UL listed products
• c-UL listed products
• Product List
UL/c-UL File No.: E220851, E210412
<Cautions>
Be aware of the following items when building the PS-A into an end-use product:
• The PS-A unit’s rear face is not approved as an enclosure. When building the PS-A unit into an end-use product, be
sure to use an enclosure that satisfies standards as the end-use product’s overall enclosure.
• The PS-A unit must be used indoors only.
• Install and operate the PS-A with its front panel facing outwards.
• If the PS-A is mounted so as to cool itself naturally, be sure to install it in a vertical panel. Also, it’s recommended that
the PS-A should be mounted at least 50 mm away from any other adjacent structures or machine parts. The tempera-
ture must be checked on the final product in which the PS-A is installed.
• For use on a flat surface of a Type 4X (Indoor Use Only) and/or 12 Type Enclosure.
Industrial Control Equipment refer to UL508
see [a] in the
“Product List“
Suitable for use in Class I, Division 2,
Groups A, B, C, and D Hazardous
(classified) locations, or Non-Hazard-
ous Locations.
refer to
ANSI/ISA 12.12.01
see [b] in the
“Product List“
Process Control Equipment
refer to CSA-C22.2
No.142 see [c] in the
“Product List“
Suitable for use in Class I, Division 2,
Groups A, B, C, and D Hazardous
(classified) locations, or Non-Hazard-
ous Locations.
refer to
CSA-C22.2 No. 213
see [d] in the
“Product List“
Product Model No. Registration Model No.
UL c-UL
[a] [b] [c] [d]
PS3710A-T41-PA1 3580301-02 9 - 9 -
PS3710A-T42-PA1 3580301-02 9 9 9 9