Proface APL3000B - Node Box PC - Manual (Page 59)

PS-3710A Series Hardware Manual
3-16
(2) As shown, insert the USB Cable Clamp’s band through the Bridge. Pass the USB cables through the
Cable Clamp’s band and securely tighten the clamp band around the cables.
„ Removing the USB Cable Clamp
(1) To remove the clamp from the USB cables, push down on the clamp strap’s clip to release it while
pulling up on the clamp.
• Be sure the clamp is securely holding the USB cable’s plug and collar.
• Be sure the clamp is positioned as shown below, with the clamp pointing upwards - not to
the side. This is to keep the clamp from interfering with nearby connectors and their
cables.
Band
Clamp
Cable collar
USB Cable
Bridge
Clip
Clamp