Watlow ANASOFT - Manual (Page 18)

8 ANASOFT User’s Guide
Installation
Installation Menu
1 to 16
Only one type. Changing
one controller’s type
would change all others’.
This value is fixed for
each controller. See
table on the next page.
The computer’s serial
communication port to the
controller. Can be only 1
Can be either
2400 0r 9600.
Set all con-
trollers to the
same value.
Set to either BCC (Block Check
Character) or CRC (Cyclic
Redundancy Check). Use BCC
for standard applications. CRC
ensures a higher degree of secu-
rity but decreases the overall
communication rate. Use CRC
only when you anticipate severe
communication noise.
Change the
screen to the
Loop group Edit
screen. See
Grouping Loops
in this section.
For these paths see the
next page.