Watlow ANAWIN 2 - Manual (Page 77)

Using the Trend Plot Screen
AnaWin User’s Guide 7-15
Pattern (default is solid): Use the Pattern pull-down list box to choose
a pattern for the selected marker. If you do not choose one, the marker
appears in a solid color.
Symbol (default is automatic symbol): Use the Symbol pull-down list
box to choose one of 14 symbol options.
By default, the Graph Control assigns an automatic series of symbols to
data sets, chosen for variety. If you override this default by setting your
own symbol for one set, you have to set symbols for any remaining sets
as well; otherwise, they will all default to the first available symbol (+).
Size: Use the Size scroll bar to set the size for symbols, based on a
default of 100 arbitrary units. Each click to the left decreases the symbol
size by 5 units (to a minimum of 10), and each click to the right
increases it by 5 units (to a maximum of 1000).
Lines: Use the options in the lines panel to specify the pattern and
thickness for the lines on the trend plot.
• Thick (default is on): Select Thick to enable thick lines, which are
three pixels thick by default. Deselect Thick for thin lines, which are
one pixel thick.
• You can use the pull-down list box to choose a line thickness
of one to five pixels (overriding the default three pixels).
This setting applies to all lines in the graph. You cannot set
your own thickness for high-low-close or open-high-low-
close markers, which are always three pixels thick when
Thick is on.
Patterned (default is off): Select Patterned to enable patterned lines,
then, use the pull-down list box to choose a pattern for each line.
Trends
Click the Trends icon to display the Trends property page, shown in
Figure 7-11. This page allows you to enable statistical lines and curve
fitting for the graph types that support these options.