APC SmartSlot Series - Manual (Page 5)

2. Installation
Use the following procedure to install SmartSlot Measure-UPS II:
1. Install and configure any software or hardware that will be used
with Measure-UPS II for data reporting (see software and hard-
ware compatibility above).
2. Using figure 2 as a guide, install Measure-UPS II in the host
SmartSlot. Use a #2 Phillips head screwdriver to remove the host
device SmartSlot cover plate. Install Measure-UPS II. Replace the
cover plate screws. Note: Measure-UPS II is sensitive to static
electricity. Handle Measure-UPS II by the end plate only. Do not
touch the exposed printed circuit board. While it is not possible to
install Measure-UPS II upside down, it is possible to damage it in
the attempt. Note that the edges of the printed circuit board align
with the locating slots in the sides of the SmartSlot. The Smart-
Slot may be oriented horizontally or vertically in the host device.
The host device may be on or off during installation.
3. Connect the supplied probe to probe connector 1 on Measure-
UPS II. Note: probe connector 2 is not used in Measure-UPS II.
4. Place the probe where desired using the supplied hook and loop
fasteners, if needed. Note: The Measure-UPS II probe is designed
for use in a controlled environment. Place it in an area that is
within the environment limits set in the specifications (see section
9.) The location must be free from direct sunlight, excessive
moisture, and dust.
Figure 2, SmartSlot installation