Watlow EZ-ZONE RM-Scanner-Modul - Manual (Page 21)

Watlow EZ-ZONE ® RMS Module • 18 • Chapter 2 Install and Wire
Removal of the Modular Back-
plane Connector
A module can be removed from
the Modular Backplane Connector
by inserting a screw driver into
the red locking tab just behind
the green connector and applying
downward pressure on the tab by
lifting the screwdriver upwards.
When released, the tab will move
downward and the connector can
then be lifted up off of the DIN
rail.
Module Removal
To remove a module from the
Modular Backplane Connector
find the red tab protruding from
the bottom of the module and pull
back on it as shown to the right.
While pulling back on the red tab
the two mounting posts will re-
lease the module where the mod-
ule can then be lifted up and out
of the Modular Backplane Con-
nector.