Watlow MINICHEF Deep Fat Fryer Application - Manual (Page 25)

A p p l i c a t i o n 1 2 Wa t l o w M I N I C H E F 2 0 0 0 ■ 2 3
Application 12
Manual Deepfat Fryer
with Autolift Control
Single Heat Channel, One Menu
Introduction to Application 12 . . . . . . . . . . . . . 23
Configuration Mode Quick Reference . . . . . . . . 25
Step 7 Design a Faceplate Overlay . . . . . . . . . . 27
Step 8 Operate the Controller . . . . . . . . . . . . . 28
Application 12 allows you to program a menu to control one temperature channel and
cooking time for a manual deepfat fryer.
Overview of Key Steps
1. Install the M INI C HEF 2000.
2. Wire the controller.
3. Configure the controller.
4. Program the menu.
5. Set the controller security.
6. Set the Real-time Clock.
For instructions on Steps 1, 2, 3, 4, 5 and 6, see the Hardware & Software Setup Guide.
7. Design, manufacture and apply faceplate overlay for end-users. (For a suggested
design to suit this application, see this section. For overlay dimensions and guide-
lines, see the Hardware & Software Setup Guide.)
8. Operate the controller. (See this application guide.)
12