Watlow Series 93 - Manual (Page 20)

4 . 2 ■ S e t u p W a t l o w S e r i e s 9 3
Setup
[`LOC] Lock
[``In] Input
[`dEC] Decimal*
[`C_F] Celsius - Fahrenheit*
[``rL] Range Low
[``rH] Range High
[`Ot1] Output 1
[`HSC] Hysteresis Control
[`Ot2] Output 2
[`HSA] Hysteresis Alarm*
[`LAT] Latching*
[`SIL] Silencing*
[`rtd] RTD*
[`rP`] Ramping
[`rT`] Rate*
[`P`L] Power Limiting*
[`dSP] Display
* Parameter may not always appear.
‰
Setup Menu
Figure 4.2b -
The Setup Menu.
NOTE:
While in the Setup
Menu, all outputs are
off.
Enter the Setup Menu by pressing the ¿Up-arrow and ¯Down-arrow keys si-
multaneously for 3 seconds. The lower display shows the
[`LOC] Lock parame-
ter, and the upper display shows its current level. All keys are inactive until you
release both keys. You can reach the Lock parameter from anywhere.
Use the ‰Advance key to move through the menus and the ¿Up-arrow and
¯Down-arrow keys to select data. You will not see all parameters in this menu,
depending on the controller's configuration and model number. After stepping
through the menu it returns to the set point parameter. If no keys are pressed for
approximately 60 seconds, the controller returns to the default display, Process
over Set Point.
Figure 4.2a -
Entering the Setup
Menu. 93 93
Menu Structure and Programming
The Series 93 controller has two menus that are used to determine the configura-
tion and operation of the controller. They are the Setup Menu and the Operation
Menu. If you are installing the Series 93 controller, you will need to determine
the proper settings for both the Setup and Operation Menus. If the controller is
already installed in equipment you have purchased, you may only need to set a
few of the parameters to adjust the controller to your specific usage of the equip-
ment. The Setup Menu displays the parameters that configure the Series 93's fea-
tures to your application.
Entering the Setup Menu